1, DMX Signal IN/OUT interface: RJ45/3 Pin screws/5 Pin XLR
connector. Specially 3 Pin screws interface with signal amplifier
2, DMX address encode with Dip-Switch(NO.1 to NO.9),comply to
universal DMX512 dial code.
3, Dip-Switch NO.10 is termination for whole signal circle.
4, Dip-Switch NO.11 for Frequency option: ON 5000HZ(H), OFF 500Hz(L).
5, Dip-Switch NO.12 for Bit option: ON 16bit ,OFF 8bit.
NOTE: NO.11 and NO.12 change, come into operation when Re-Power on.
6, POWER IN DC12-24V, common anode constant voltage output, can meet
all kinds of full color module andmonochrome module and
automatically according to the lamps module load adjust output
current, each channelmaximum current not more than 4 amps.
7, SELF-TESTING: put all Dip-Switch NO.1 to NO.9 off, full channels output 3
seconds, then each color gradient.
Instructions about Connection:
1, DMX signal cable is made of twisted pair (line), DMX signal
includes positive and negative end, in pressure welding DMX signal
line plug should pay special attention to polarity. DMX512
controller input and output signal positive,signal nagative,signal
ground with DE8532 input interface corresponding connection.
2, The DMX5000 output and DE8532's transmission lines can't be over
3, The DMX5000 each interface can connect with no more than 170
pieces of DE8532. Eight output interface. Through the JBLED FLASH
light making software,it can realize infinite connectting the DMX
lights with computer on-line controlling.
4, When contacting 32 pieces of DE8532, DMX signal must add a signal
amplifier such as RE2000,cascade can't more than 4 PCS.
5, At the end of the connection, we should connect a DMX signal
termination when putting on the the NO.10 dip switch of DE8532.