DIN Rail Version Rf Led Controller / Led Light Controller With ABS Material

Max 5A*4CH DIN Rail Version DMX512 Decoder LED Dimmer Controller

Model : DE8704 Manual Download:DE8704 .pdf

SUMMARIZE:

DE8704 is the 4 channels product of DIN Rail DMX512 Decoder Series. DIN rail products is widely used Lighting field. It can realize removing after installing within a fixed rail. It can be wall mounted or inverted as you need. Much more easy to install and operation, beautiful appearance and rich function, this products will be your best choice of DIN rail DMX decoder.

Product Features:

1), Meets DMX512/1990,with RJ45 interface.

2), 256-levels brightness,full-color with driver controls.

3), Power without flashing, low jitter free.

4), 4 ways of output channel, single channel maximum 5A output drive, total output is less than 20A.

5), Can achieve asynchronous color changes effect under working with controller.

6), With the light color selected mechanism, and be able to control the light with 1~4 colors.

7), Setting the DMX address freely.

8), Modularizing and can be matched with different LED module neatly.

9), With function of DIN rail.

10), Custom-made is available and 3 years warranty.

Technical Parameters:

Product Size:

Specifications of DIN Rail Series:

Product Instructions of 4CH DIN Rail DMX Decoder DE8704:

1. The driving output interface of Yang drive, with 1 V+ ports and 4 channels CH1, CH2, CH3, CH4
output interface,can be connected with various full-color module and module automatically according to the lamp module load adjustment of output current, each channel shall not be greater than 5A.

2. Note: the total connection full-color module directly to the main line and CH1, CH2, CH3, CH4 control line is connected to the output of the decoder interface corresponding pins; single module can be connected to the decoder output interface is V+ feet, negative lines according to the output of CH1, this module is connected to the CH2 color decoder CH3, CH4, a foot on amonochrome module; several colors received the same decoder output interface, will be their main line are connected to a decoder of V+ feet.

3. Self-test Function: full bright mode, will be 1 to 9 of the dial switch upward pull full bright. Four
channel gradient mode, will be 1 to 9 of the dial switch down to pull out the channel gradient mode.

Wiring Diagram:

DMX512 Control System Connection:

1), DMX signal cable is shielded twisted pair cable(microphone cable) or three core cable, DMX signal positive, negative in the end, solder or crimp DMX signal cable plug should be paid special attention to the polarity.The input interface and corresponding signal output from the DMX512 controller, signal is negative, and the connection of DE8704 signal.
2), The DMX5000 output and DE8704 transmission line can't exceed 300 meters.
3), DMX5000 and DE8704 wiring, lighting by JBLED FLASH software can realize the control and
computer on-line,realize unlimited expansion cascade with DMX lamp.
4), Every connected 32 DE8704 control, DMX signal must be combined with a signal amplifier (such
as: RE2000),cascade cannot be more than 4PCS.
5), At the end of the line, shall be connected to a DMX signal termination (DE8704 dial switch tenth dial can).